IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
Setpoint: DNS IP
ï‚· In fixed settings mode this setpoint is used to adjust the domain name
server (DNS), which is needed to traslate domain names in e-mail
addresses and server names into correct IP addresses.
ï‚· In Automatic settings mode this setpoint is used to display DNS server,
which has been assigned by the DHCP server. It is not possible to change
the setpoint value manually in this setting (the value is immediately
reverted back by controller communication module IB-COM).
Setpoint: ECU Diag
This setpoint is used to disable reading of diagnostic codes from the ECU if an
external diagnostic tool is connected to the engine.
A message ECU Diag disabled is displayed in the alarm list while ECU
diagnostics is disabled.
Setpoint: SHxOcol detect
This setpoint is used to enable/disable evaluation of collisions of virtual shared
peripherial modules. A collision means that there is more than one source (shared
outputs module) active on the CAN2 bus.
NOTE:
In certain situations multiple sites with bus tie breakers may need to have more
shared outputs sources as the CAN bus line is in some points interrupted
according to bus tie breakers position. Normally a collision would be indicated if
there were more sources on the bus and this setpoint can be used to disable the
evaluation of collisions in this special case.
Group: Engine params
Setpoint: Starting RPM
To Next Page
Loading...
Need help?
General
