IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
ï‚· In fixed settings mode this setpoint is used to adjust the IP address of the
ethernet interface of the controller. Ask your IT specialist for help with this
setting.
ï‚· In Automatic settings mode this setpoint is used to display the IP address,
which has been assigned by the DHCP server. It is not possible to change
the setpoint value manually in this setting (the value is immediately
reverted back by controller communication module IB-COM).
Setpoint: IP Addr mode
The setpoint is used to select the method how the ethernet connection is adjusted.
The ethernet connection is adjusted fixedly according to the
setpoints IP address, Net mask, Gateway IP, DNS IP. .
This method should be used for classic ethernet or Internet
connection. When this type of connection is opening the
controller is specified by it's IP address. That means it would
be inconvenient if the IP address were not fixed (static).
The ethernet connection settings is obtained automatically
from the DHCP server. The obtained settings is then copied
to the related setpoints (it is not possible to set those
setpoints manually in this setting, for more information
please see the following setpoints: IP address, Net mask,
Gateway IP and DNS IP). If the process of obtaining the
settings from DHCP server is not successful the value
000.000.000.000 is copied to the setpoint IP address and the
module continues trying to obtain the settings.
This method is beneficial for AirGate connection as it makes
the connection very easy, in fact "plug and play". When this
type of connection is opening the controller is specified by it's
AirGate ID and the IP address does not play any role.
CAUTION!
If you need to use fixed ethernet settings you should consult the proper setting
with your IT specialist.
Setpoint: Net mask
To Next Page
Loading...
Need help?
General
