IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
Setpoint: BinInp delay 1
This setpoint adjusts the delay #1 which can be assigned to an input configured
as alarm input (protection).
NOTE:
Protections configured at a binary inputs can have either fixed 0.5s evaluation
delay or there are three independent delay setpoints and one of them can be
assigned to each particular binary input protection.
Setpoint: BinInp delay 2
This setpoint adjusts the delay #2 which can be assigned to an input configured
as alarm input (protection).
NOTE:
Protections configured at a binary inputs can have either fixed 0.5s evaluation
delay or there are three independent delay setpoints and one of them can be
assigned to each particular binary input protection.
Setpoint: BinInp delay 3
This setpoint adjusts the delay #3 which can be assigned to an input configured
as alarm input (protection).
NOTE:
Protections configured at a binary inputs can have either fixed 0.5s evaluation
delay or there are three independent delay setpoints and one of them can be
assigned to each particular binary input protection.
Setpoint: ForceBlockDel1
This setpoint adjusts the delay after the binary input Force block 1 has been
deactivated, when the alarms configured as Force block #1 are started to be
To Next Page
Loading...
Need help?
General
