ComAp IS-NTC-BB Reference Guide

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
186
Related FW
3.0
Description
This setpoint is used to select the gen-sets which will run within the power band
#1 if the optimalization according to gen-set size is active. Learn more about this
topis in the chapter Gen-set size optimalization.
NOTE:
The combinations of gensets must be created so, that the total nominal power of
the Power band #1 < #2 < #3 < #4.
Setpoint: #PwrBandContr 2
Group
Pwr management
Range [units]
1, 2, 1+2, 3, 1+3, 2+3, 1+2+3 [-]
Related FW
3.0
Description
This setpoint is used to select the gen-sets which will run within the power band
#2 if the optimalization according to gen-set size is active. Learn more about this
topis in the chapter Gen-set size optimalization.
NOTE:
The combinations of gensets must be created so, that the total nominal power of
the Power band #1 < #2 < #3 < #4.
Setpoint: #PwrBandContr 3
Group
Pwr management
Range [units]
1, 2, 1+2, 3, 1+3, 2+3, 1+2+3 [-]
Related FW
3.0
Description
This setpoint is used to select the gen-sets which will run within the power band
#3 if the optimalization according to gen-set size is active. Learn more about this
topis in the chapter Gen-set size optimalization.
NOTE:
The combinations of gensets must be created so, that the total nominal power of
the Power band #1 < #2 < #3 < #4.
Setpoint: #PwrBandContr 4
Group
Pwr management
Range [units]
1, 2, 1+2, 3, 1+3, 2+3, 1+2+3 [-]
Related FW
3.0
Description
This setpoint is used to select the gen-sets which will run within the power band
#4 if the optimalization according to gen-set size is active. Learn more about this
topis in the chapter Gen-set size optimalization.
NOTE:
The combinations of gensets must be created so, that the total nominal power of
the Power band #1 < #2 < #3 < #4.

ComAp IS-NTC-BB Specifications

General

Brand	ComAp
Model	IS-NTC-BB
Category	Controller
Language	English