EasyManuals Logo

ComAp IS-NTC-BB Reference Guide

ComAp IS-NTC-BB
361 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #187 background imageLoading...
Page #187 background image
IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
187
Setpoint: #PwrBnChngDlUp
Group
Pwr management
Range [units]
0 .. 3600 [s]
Related FW
3.0
Description
This setpoint is used for adjusting the delay of changing the power band if the load
demand rose above the upper limit of the current power band. Learn more about
this topis in the chapter Gen-set size optimalization.
Setpoint: #PwrBnChngDlDn
Group
Pwr management
Range [units]
0 .. 3600 [s]
Related FW
3.0
Description
This setpoint is used for adjusting the delay of changing the power band if the load
demand dropped below the lower limit of the current power band. Learn more
about this topis in the chapter Gen-set size optimalization.
Setpoint: Control group
Group
Pwr management
Range [units]
COMMON (=1), 2 .. 32 [-]
Related FW
3.0
Description
This setpoint selects the logical group to which the particular gen-set belongs. If
there aren't logical groups at the site, adjust the setpoint to 1 (COMMON).
Setpoint: GroupLinkLeft
Group
Pwr management
Range [units]
COMMON (=1), 2 .. 32 [-]
Related FW
3.0
Description
If the input GroupLink of this particular controller is used to provide the "group link"
information for two logical groups, then this setpoint is used to select which group
is located at the left side of the group link breaker (bus tie breaker). If this
particular controller is not used for the group link function adjust this setpoint to 1
(COMMON).
Setpoint: GroupLinkRight
Group
Pwr management
Range [units]
COMMON (=1), 2 .. 32 [-]
Related FW
3.0
Description
If the input GroupLink of this particular controller is used to provide the "group link"
information for two logical groups, then this setpoint is used to select which group
is located at the right side of the group link breaker (bus tie breaker). If this
particular controller is not used for the group link function adjust this setpoint to 1

Table of Contents

Other manuals for ComAp IS-NTC-BB

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ComAp IS-NTC-BB and is the answer not in the manual?

ComAp IS-NTC-BB Specifications

General IconGeneral
BrandComAp
ModelIS-NTC-BB
CategoryController
LanguageEnglish

Related product manuals