EasyManuals Logo

ComAp IS-NTC-BB Reference Guide

ComAp IS-NTC-BB
361 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #236 background imageLoading...
Page #236 background image
IGS-NT Combi, SW Version 3.0, ©ComAp May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
236
Units
V
Related FW
3.0
Description
This value shows average Bus voltage in phase L2.
Value: Mains Avg V3
Group
Mains values
Units
V
Related FW
3.0
Description
This value shows average Mains voltage in phase L3.
Value: Bus Avg V3
Group
Bus values
Units
V
Related FW
3.0
Description
This value shows average Bus voltage in phase L3.
Value: ROCOF
Group
Mains values / Bus values
Units
Hz/s
Related FW
3.0
Description
This value shows actual measured value of ROCOF.
Value: Max ROCOF
Group
Mains values / Bus values
Units
Hz/s
Related FW
3.0
Description
This value shows maximal measured value of ROCOF.
Group: Power management
Value: EnginePriority
Group
Pwr management
Units
-
Related FW
3.0
Description
This value shows current priority number. It corresponds to the setpoint Priority
except following situations:
If at least one of binary inputs Priority SW "X" is configured on some
source and is active then the actual gen-set priority is given by the
combination of these inputs.
If a force value function is configured at the Priority setpoint and the
forcing binary input is active, the actual gen-set priority is given by the
alternative setting from the force value function.
If the Gen-set size optimalization is active then the actual priority is given

Table of Contents

Other manuals for ComAp IS-NTC-BB

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ComAp IS-NTC-BB and is the answer not in the manual?

ComAp IS-NTC-BB Specifications

General IconGeneral
BrandComAp
ModelIS-NTC-BB
CategoryController
LanguageEnglish

Related product manuals