IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
Value: TotRunPact P
Sum of active power of all gen-sets within the group that are connected to the
bus.
Value: netPgnomPh
Sum of nominal power of all gen-sets within the group that are connected to the
bus.
Group: Volt/PF ctrl
Value: VoltRegOut
This is the actual PWM percentage on the AVRi output of the controller.
Value: SystPfCtrl
Code of the current power factor control mode. The description how to obtain the
text representation of each code can be found at the value Engine state.
Group: Force value
Value: ExtValue1
This data object is intended for remote control of the gen-set via the
communication if some kind of data is to be passed into the controller.
This object can be written via the communication (e.g. Modbus) without any
limitation. Use GenConfig function Generate Cfg Image to get the communication
object number or register number of this particular value object. Below is a typical
example of using this object.
EXAMPLE:
The gen-set is required to be running in parallel-to-mains mode at constant load
To Next Page
Loading...
Need help?
General
