Need help?Do you have a question about the COMBA mBDA OD Series and is the answer not in the manual?
Lists key features of the mBDA Digital Band Selective Repeater.
Illustrates the internal components and signal flow of the mBDA.
Diagrams showing the internal arrangement of mBDA components.
Details the various components that make up a typical mBDA unit.
Lists the components included in the mBDA equipment kit.
Lists critical warnings and alerts for installation safety.
Factors to consider for optimal equipment installation location and environment.
A checklist to ensure all requirements are met before and during installation.
Procedures for checking received equipment for damage and completeness.
Lists recommended tools for installation and maintenance.
Steps for preparing the mounting rack.
Instructions for mounting the mBDA unit on a wall.
Recommendation for cable entry to prevent water accumulation.
Steps to perform before powering and commissioning the equipment.
Explains the function of the diagnostic LEDs on the MCU panel.
Step-by-step guide for system commissioning.
Steps to connect to the Web GUI via an OMT port and PC.
Overview of the Web GUI main screen and menu bars.
Shows the actual active modules of the mBDA within the Web GUI.
Describes the workflow for the commissioning process via Web GUI.
Details functions for upgrading and swapping firmware versions.
Overview of configuration options available in the Management screen.
Detailed step-by-step guide for system commissioning using the Web GUI.
Periodic inspection and verification of repeater operation and physical condition.
A list of recommended tools for installation and maintenance.
Form for requesting Return Material Authorization.
To Next Page
General