COMBA mBDA OD Series - GOODS INWARDS INSPECTION; TOOLS; PREPARATION

INSTALLATION GUIDE FOR mBDA OD SERIES
ENU STATUS : 1-0-0
Copyright - refer to title page
Page 19
3.3 INSTALLATION PROCEDURES
3.3.1 GOODS INWARDS INSPECTION
 Verify the number of packages received against the packing list.
 Check all packages for external damage; report any external damage to the shipping courier. If there
is damage, a shipping agent should be present before unpacking and inspecting the contents because
damage during transit is the responsibility of the agent.
 Open and check each package against the packing list. If any items are missing, contact Comba.
 Do not remove items from anti-static packing until ready for installation. If damage is discovered at the
time of installation, contact the shipping agent.
3.3.2 TOOLS
See Appendix A for a full list of the recommended tools required for installation and routine maintenance.
3.3.3 PREPARATION
 Wall mounting with the masonry bolts supplied, which make use of the outer holes.
Figure 7: Mounting Rack Overview