Nonverbal Messaging
68 Comdial Sept ‘04
3. Dial extension number or press DSS/BLF button of station that
was alerted. The message-waiting light of called station turns
off.
To turn off the message-waiting light during message-delivering con-
versation, press INTERCOM once if off-hook, twice if on-hook.
To receive a message at an alerted
station,
1. Observe flashing message wait-
ing light and the LCD message
indicating who called for you.
2. Select CALL to dial the messag-
ing station automatically.
3. Select CLEAR to clear the mes-
sage from your station.
5.3 Response Message Delivery
By programming one or more RESPONSE MESSAGE buttons on
your EP100, you can respond with a variety of messages to many
calling situations. A scrolling RESPONSE MESSAGE button allows
the sender to select from several different messages which have been
programmed by the system attendant. A fixed RESPONSE
MESSAGE button sends the same message you previously select
each time it is pressed. (See Section 6.4, LCD Feature Buttons for
instructions on programming a dedicated RESPONSE MESSAGE
button.)
To send an LCD message when you call and receive busy signal or no
answer,
1. While still on the call, press the appropriate RESPONSE MES-
SAGE button to send a preselected message to the other tele-
phone,
Call J Doe
CALL
CLEAR
Receiving a Message
To Next Page
Loading...
