CONVERSip EP100 User
Sept ‘04 Comdial 93
7.10 Default Volume Control
You can set a permanent loudness level for any volume control
setting. The level will remain at this volume (referred to as the
default setting) until you change the setting.
To set a permanent speaker, headset, handset, or group listening
loudness for all future calls,
1. Press INTERCOM.
2. Activate speaker, headset, handset, or group listen mode to be
affected.
3. While in that mode, press VOLUME Up or VOLUME Down
button to adjust loudness.
4. Dial **7 or press programmed SAVE button to hold the loud-
ness at the last setting for all future calls (until you change the
default again).
5. Repeat this procedure in each mode until you’ve set all default
volume levels.
7.11 Programmed Button Display
7.11.1 BUTTON FUNCTIONS DISPLAY (BUTTON
QUERY)
You can cause the display to identify the function of each button on
your telephone.
To Next Page
Loading...
