Comdial DX-80 - Page 293

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-243
• Use ¢£¤¥ to highlight “Attribute.”
• Press « to select the appropriate attribute for this UCD Group.
• Use ¢£¤¥ to highlight “Tenant Group.”
• Press « to select the appropriate tenant group for this UCD Group.
• Use ¢£¤¥ to highlight “Name.”
• Press «.
• Input the name for this UCD Group. Then press «.
• Use ¢£¤¥ to highlight “Member.”
• Press «.
• Use ¢£¤¥ to highlight “MemX” (the Member to program). Then press «.
• Input the extension number for this Member. Then press «.
• Repeat from use ¢£¤¥ to highlight “MemX” for all member to be programmed.
• When finished programming members, press °.
• When prompted to “Exit this Feature,” press “Y” (yes).
• Use ¢£¤¥ to highlight “Hunting Method.”
• Press « to select the appropriate Hunting Method for this UCD Group.
• Use ¢£¤¥ to highlight “No Answer Timer.”
• Press «.
• Input the appropriate No Answer Timer for this UCD Group. Then press «.
• Use ¢£¤¥ to highlight “Overflow 1 Timer.”
• Press «.
• Input the appropriate Overflow 1 Timer for this UCD Group. Then press «.
• Use ¢£¤¥ to highlight “Overflow 1 Dest.”
• Press «.
• Input the appropriate Overflow 1 Destination for this UCD Group. Then press «.
• Use ¢£¤¥ to highlight “Overflow 2 Timer.”
• Press «.
• Input the appropriate Overflow 2 Timer for this UCD Group. Then press «.
• Use ¢£¤¥ to highlight “Overflow 2 Dest.”
• Press «.
• Input the appropriate Overflow 2 Destination for this UCD Group. Then press «.
• Use ¢£¤¥ to highlight “Overflow Count.”
• Press «.
• Input the number of times that Overflow 2 Destination should be played (RAD) for this UCD Group.
Then press «.