Comdial DX-80 - Page 292

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-242
• 06-01-01~24-07 (UCD Group input Overflow 1 Destination)
• Press [chg].
• Input appropriate Overflow 1 Destination.
• Press [save ].
• Press [next ].
• 06-01-01~24-08 (UCD Group select Overflow 2 Timer)
• Press [chg].
• Input appropriate Overflow 2 Timer.
• Press [save ].
• Press [next ].
• 06-01-01~24-09 (UCD Group input Overflow 2 Destination)
• Press [chg].
• Input appropriate Overflow 2 Destination.
• Press [save ].
• Press [next ].
• 06-01-01~24-10 (UCD Group select Overflow Count)
• Press [chg].
• Input appropriate Overflow Count.
• Press [save ].
• Press [next ].
• 06-01-01~24-11 (UCD Group input Reroute Destination)
• Press [chg].
• Input appropriate Reroute Destination.
• Press [save ].
• Press [next ].
• Press the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.
• Select Programming from the PC-DBA menu. Then press «.
• Use ¢£¤¥ to highlight “Extension Application” and then press «.
• Use ¢£¤¥ to highlight “Uniform Call Distribution” and then press «.
• Input the UCD Group to program 1-24. Then press «.