DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-248
• Use [back] and [next] to select the UCD Group Member for programming.
• Press [chg].
• Input the extension directory number of the analog extension to assign as this V.A. UCD Group
Member.
• Press [save ].
• Repeat from [next], [back ] for additional Members.
• Press the Hold button when finished entering members.
• Press the Hold button to return to the previous menu level or press the Volume button (up or
down) to return to the DB Item Selection screen or exit programming.
Programming via PC-DBA
Note: PC-DBA is a DOS-based programming utility.
• Enter PC-DBA by typing “DX-80” at the DOS prompt in the PC-DBA working directory and then pressing
«.
• Press any key at the program title page (as it requests) to enter the Main Menu.
• Select PC-DBA from the main menu.
• Select Programming from the PC-DBA menu. Then press «.
Program analog extensions as port type “V.A.”:
• Use ¢£¤¥ to highlight “Extension.” Then press «.
• Use ¢£¤¥ to highlight “Category 2.” Then press «.
• Use ¢£¤¥ and ³´ to highlight “Port Type” for the analog extension to program.
• Press « until the appropriate Port Type (V.A.) displays.
• Continue programming port type for other analog extensions as required.
• When all changes are made press the ° (escape) key to exit this database-programming screen. You will
see the prompt: “Exit This Feature”; press “Y” for yes.
• You will then be prompted to “Save Current Setting?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” to save changes.
• If you press “Y” (yes), you will then be prompted “File Exists, Override?”
• Press “N” to abort changes and leave all data unchanged.
• Press “Y” (yes) to continue with the save operation.
• Press ° (escape) again to return to the Database Programming menu.
Program the Voice Announcer UCD Group:
• Use ¢£¤¥ to highlight “Extension Application.” Then press «.
• Use ¢£¤¥ to highlight “Uniform Call Distribution.” Then press «.
• Input the UCD Group number to be used as the V.A. Group, then press «. This advances to the selected
UCD Group with the cursor positioned on the “Attribute” database item.
• Use ¢£¤¥ to highlight “Members.” Then press «. This advances to this UCD Group Members
database screen.
• Use ¢£¤¥ to highlight the Member to be changed. Then press «.
To Next Page