DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-254
• Press [next ].
• Continue from [chg] above to program all Voice Mail ports as member of this UCD Group.
• Press the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
06-02-1~3-01 (Voice Mail Hunt Group, where 1~3 is the Tenant Group {usually “1”})
• Press [save ]. This advances to Voice Mail Table for Tenant 1 – Hunt Group.
• Press [chg] until the UCD Group to be used as the VM Hunt Group displays. (UCD Group where all of
the VM type analog ports are programmed as Members.)
• Press [next ] to continue programming the various call handling digits (Prefix/Suffix).
• Press the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
06-02-1~3-02-01 (VM Table – Prefix Table – ICM/VM, where 1~3 = Tenant Group)
• Press [save ].
• Press [chg].
• Input the required digits to identify this call as originated at the subscriber phone.
• Press [save ].
• Press [next ] to continue programming the various call handling digits (Prefix/Suffix).
• Press the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
06-02-1~3-02-02 (VM Table – Prefix Table – Transfer, where 1~3 = Tenant Group)
• Press [save ].
• Press [chg].
• Input the required digits to identify this call as transferred to this subscriber MB.
• Press [save ].
• Press [next ] to continue programming the various call handling digits (Prefix/Suffix).
• Press the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
06-02-1~3-02-02 (VM Table – Prefix Table – Busy FWD, where 1~3 = Tenant Group)
• Press [save ].
• Press [chg].
• Input the required digits to identify this call as forwarded from this busy subscriber.
• Press [save ].
• Press [next ] to continue programming the various call handling digits (Prefix/Suffix).
• Press the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
To Next Page
Loading...
