Comdial DX-80 - Page 306

DX-80 INSTALLATION AND MAINTENANCE MANUAL
P7290 IMM 3-256
• Press [next ] to continue programming the various call handling digits (Prefix/Suffix).
• Press the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
06-02-1~3-03 (VM Table – Suffix Digit, where 1~3 = Tenant Group)
• Press [save ].
• Press [chg].
• Input the suffix digits if required to identify this call as the MB subscriber.
• Press [save ].
• Press [next ] to continue programming the various call handling digits (Prefix/Suffix).
• Press the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
06-02-1~3-03 (VM Table – Record Digit, where 1~3 = Tenant Group)
• Press [save ].
• Press [chg].
• Input the digits required to active recording in this subscriber MB.
• Press [save ].
• Press [next ] to continue programming the various call handling digits (Prefix/Suffix).
• Press the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
06-02-1~3-03 (VM Table – Delete Digit, where 1~3 = Tenant Group)
• Press [save ].
• Press [chg].
• Input the digits required to delete the current recording in this subscriber MB.
• Press [save ].
• Press [next ] to continue programming the various call handling digits (Prefix/Suffix).
• Press the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.
06-02-1~3-03 (VM Table – Disconnect Digit, where 1~3 = Tenant Group)
• Press [save ].
• Press [chg].
• Input the digits required to force disconnect of the active port.
• Press [save ].
• Press [next ] to continue programming the various call handling digits (Prefix/Suffix).
• Press the Hold button to return to the previous menu level or press the Volume button (up or down) to
return to the DB Item Selection screen or exit programming.