GCA70258 LCD Speakerphone Station User’s Guide
August, 03 Comdial 67
6.6 Response Message Button
You may program a RESPONSE MESSAGE button, which allows
you to send an LCD message to a caller who has initiated a SOHVA
or intercom call from another LCD speakerphone, or to send an LCD
message to another LCD speakerphone that you call and receive a
busy signal or no answer.
• To store a scrolling RESPONSE MESSAGE button, proceed
as follows (user may press button repeatedly to choose from
up to 30 system supplied messages),
1. PRESS INTERCOM
2. DIAL **6.
3. PRESS programmable button for RESPONSE MESSAGE button
location.
4. DIAL 00
5. DIAL # to save programming.
6. PRESS SPEAKER to end.
7. LABEL the button location.
• To store a fixed RESPONSE MESSAGE button (delivers the
same message each time it is pressed),
1. PRESS INTERCOM.
2. DIAL **6
3. PRESS programmable button for RESPONSE MESSAGE button
location.
4. DIAL message number (01-30) from list of messages.
5. DIAL # to save programming.
6. PRESS SPEAKER to end.
7. LABEL the button location.
Note: Programmed messages available for use are created by the
system attendant and listed in a table on page.
To Next Page
Loading...
