Comelit 8461V - Programming Range; Monitor Ringtone Selection

24
Carry out steps 1 to 4
Programming range
Monitor ringtone selection
Take note of the S2, S1 setting and restore it when programming is complete
1. Press and hold
for 6 sec.
» a confirmation tone will sound
» the privacy LED will flash to indicate “programming” mode.
√ The procedure can only take place while the system is in standby; otherwise the privacy LED will flash 4 times to inform the
user that the system is engaged
2. Press and release
Once (1 confirmation tone is emitted) to change the ringtone for calls from the external unit.
Twice (2 confirmation tones are emitted) to change the ringtone for calls from the switchboard.
3 times (3 confirmation tones are emitted) to change the ringtone for intercom calls made from the internal unit.
4 times (4 confirmation tones are emitted) to change the floor door call ringtone.
Any further pressing of the key repeats the sequence described above.
3. Press and release
to scroll through the various available ringtones in sequence.
4. Press
to confirm selection of the last ringtone heard and to exit (at any time) change monitor ringtone mode.
» one confirmation tone is emitted
» the privacy LED switches o
5. Repeat steps 1 to 4 to change the other ringtones.
1) 2) 3) 4)
Range minimum
address
S1
set code, TAB. A
on page 13
S2 DIP
1 2 3 4 5 6
0 0 0 0 1 0
S2
S2
Range maximum
address
Enable range
Disable range
Deleting the range
DIP OFF
DIP ON
S1
S2 DIP
1 2 3 4 5 6
1 1 1 1 1 0
S2
2 sec