Commodore PC 20 - Page 193

Exit
Purpose:
Exits the command.com program (the command processor) and
returns
to a previous level, if one exists. .
Syntax:
exit
Comments:
If you use the MS·DOS command program to start a new command
processor, you can use the exit command to return to the old
command processor. Also, while running an application program,
you can
exit to the MS· DOS command processor, and then return to
your program.
Refer
to the command command in this chapter for more
information.
Example:
If you start a new command processor by typing the following
command, you can then
return to the previous command proces-
sor by typing the exit command:
command c:\
MS-DOS Commands 551
Exit