CommScope Touchstone TG6452 - Internet LED Status Patterns; WPS LED Status Patterns; Wi-Fi LED Status Patterns; Using the Reset Button

Light paerns for the Internet LED during normal operaon
Event LED Status
Downstream scanning in progress Red (slow blink)
Upstream ranging in progress Red (fast blink)
Ranging completed; registraon in progress White (slow blink)
Cable modem was successfully registered White (steady)
Cable modem failed to register Red (steady)
WPS LED
Light paerns for the WPS LED during normal operaon
Event LED Status
WiFi switched o O
Synchronizing WPS White (fast blink)
WiFi LED
Light paerns for the WiFi LED during normal operaon
Event LED Status
WiFi switched o O
WiFi switched on White (blinking)
WiFi data is being transmied White (blinking)
WiFi disabled due to scheduling O
Use the Reset buon
Use the Reset buon on the back of the Telephony Gateway to reset and inialize the
modem as if you had power cycled the unit. You may need to reset the Telephony Gateway if
you are having problems connecng to the Internet. You will not use this buon oen.
Use a pointed non-metallic object to press this buon. The Reset buon is recessed to
prevent accidental resets.
Chapter 5: Operate the Telephony Gateway
Touchstone TG6452 Telephony Gateway User Guide DRAFT Revision 2.3 32