EasyManuals Logo

CommScope Touchstone TG6452 User Manual

CommScope Touchstone TG6452
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Chapter 1
Safety requirements
The ARRIS Telephony Gateway complies with the applicable requirements for performance,
construcon, labeling, and informaon when used as outlined below:
CAUTION:
Potenal equipment damage.
Potenal loss of service.
Connecng the Telephony Gateway to exisng telephone wiring should only be
performed by a professional installer. Physical connecons to the previous telephone
provider must be removed and the wiring must be checked; there must not be any
voltages. Cancellaon of telephone service is not adequate. Failure to do so may
result in loss of service and/or permanent damage to the Telephony Gateway.
CAUTION:
This device is restricted to indoor use.
The Telephony Gateway is designed to be connected directly to a telephone.
Connecng the Telephony Gateway to the home’s exisng telephone wiring should only
be performed by a professional installer.
Do not use product near water (i.e. wet basement, bathtub, sink or near a swimming
pool, etc.), to avoid risk of electrocuon.
Do not use the telephone to report a gas leak in the vicinity of the leak.
The product shall be cleaned using only a damp, lint-free, cloth. No solvents or cleaning
agents shall be used.
Do not use spray cleaners or aerosols on the Telephony Gateway.
Avoid using and/or connecng the equipment during an electrical storm, to avoid risk of
electrocuon.
Do not locate the equipment within 6 feet (1.9 m) of a ame or ignion source (i.e. heat
registers, space heaters, replaces, etc.).
Use only the external AC power adapter (if provided) and power cord included with the
equipment.
Equipment should be installed near the power outlet and should be easily accessible.
The shield of the coaxial cable must be connected to earth (grounded) at the entrance to
the building in accordance with applicable naonal electrical installaon codes. In the
U.S., this is required by NFPA 70 (Naonal Electrical Code) Arcle 820. In the European
Union and in certain other countries, CATV installaon equipotenal bonding
requirements are specied in IEC 60728-11, Cable networks for television signals, sound
signals and interacve services, Part 11: Safety. This equipment is intended to be
installed in accordance with the requirements of IEC 60728-11 for safe operaon.
Touchstone TG6452 Telephony Gateway User Guide DRAFT Revision 2.3 5

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the CommScope Touchstone TG6452 and is the answer not in the manual?

CommScope Touchstone TG6452 Specifications

General IconGeneral
BrandCommScope
ModelTouchstone TG6452
CategoryGateway
LanguageEnglish

Related product manuals