Comnet CWGE2FE8MSPOE - Page 39

32
spanning-tree
forward-time [seconds]
G
Use the spanning-tree
forward-time global
configuration
command to set the
forwarding-time for the
specified
spanning-tree
instances. The
forwarding time
determines how long
each of the listening
and
learning states last
before the port begins
forwarding.
switch(config)#spanning-tree
forward-time 20
stp-path-cost
[1~200000000]
I
Use the spanning-tree
cost interface
configuration
command to set the
path cost for Spanning
Tree Protocol (STP)
calculations. In the
event of a loop,
spanning tree
considers the path cost
when selecting
an interface to place
into the forwarding
state.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-path-cost 20