Comnet CWGE2FE8MSPOE - Page 40

33
stp-path-priority
[Port Priority]
I
Use the spanning-tree
port-priority interface
configuration
command to configure
a port priority that
is used when two
switches tie for
position as the root
switch.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-path-priority
128
stp-admin-p2p
[Auto|True|False]
I
Admin P2P of STP
priority on this
interface.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-p2p
Auto
stp-admin-edge
[True|False]
I
Admin Edge of STP
priority on this
interface.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-edge
True
stp-admin-non-stp
[True|False]
I
Admin NonSTP of STP
priority on this
interface.
switch(config)#interface
fastEthernet 2
switch(config-if)#stp-admin-non-s
tp False
show spanning-tree
E
Displays a summary of
the spanning-tree
states.
switch>show spanning-tree
no spanning-tree
G
Disable spanning-tree.
switch(config)#no spanning-tree