Compaq 147092-001 - KVM Switch - PS/2 - Performing a Soft Switch; Performing a Screen Capture

4-28 Compaq Server Console Switch User Guide
2. Double-click on the computer name or port
or
Highlight the port and press Enter
or
Type the port number or first few letters of the computer name to
establish is as unique, then press Enter.
Performing a Soft Switch
After opening the OSD menus, you can switch between computers without
having the OSD menus display. To perform a soft switch:
1. Click Setup | Menu.
2. Type in a time to delay displaying the Main OSD menu after Print Scrn
is pressed.
3. Click OK.
4. At the Main menu screen, type the port number or first few letters of the
computer name to establish it as unique and press Enter.
5. To switch to another computer, press Print Scrn and type the port
number or first few letters of the computer name. If the switch is
performed before the Delay time has expired, the OSD menus do not
display.
Performing a Screen Capture
In the Server Console Switch system, pressing Print Scrn opens the OSD
Menus. To print a screen capture displayed by a computer, use the following
procedures:
■ On a computer connected to a primary switch: press Print Scrn twice.
The first keystroke opens OSD menus in the primary switch. The second
keystroke clears the screen, sends the keystrokes through to the other
device, then captures or prints the screen.
■ On a computer connected to a secondary switch in a tiered
configuration: press Print Scrn four times. The first keystroke brings up
the OSD in the primary switch. The second keystroke brings up the
OSD in the secondary switch. The third keystroke brings up both OSDs.
The fourth keystroke clears the screen, then captures or prints the
screen.