Compaq 147092-001 - KVM Switch - PS/2 - Canceling Scan Mode; Setting a Custom Scan Pattern

Using the Simplified OSD 5-11
Canceling scan mode
Press any key (except Print Scrn) or move the mouse; the scan stops at the
currently selected computer.
Setting a custom scan pattern
To set a custom scan pattern:
1. In the Advanced Menus screen, move the highlight to the Setup menu.
2. Highlight Scan and press Enter; the Scan Pattern Setup screen appears
with the first port position (or computer name) highlighted.
SCAN PATTERN SETUP
Port Sec Name
1 20 Computer 1
2 20 Computer 2
F2 for defaults
Figure 5-7. Scan Pattern Setup screen
3. Type the port number of the first computer to be included in the scan
or
If your computers are listed by name, type the first few letters of the
name of the first computer to be included in the scan.
4. Move the highlight to the Sec column, and then type the number of
seconds you want this computer to be selected before switching to the
next computer in the sequence.
5. Move the highlight to the next line and repeat steps 3 and 4 for each of
the remaining computers.
6. Press Enter to save the settings and exit the menu; the new scan pattern
replaces the standard or previous custom scan pattern
or
F10 to restore default settings
or
Esc to exit the menu without saving the settings.