Permanently disabling Embedded Security
To permanently disable Embedded Security:
1. Select Start > All Programs > HP ProtectTools Security Manager.
2. In the left pane, click Embedded Security, and then click Advanced.
3. In the right pane, under Embedded Security, click Disable.
4. Type your owner password at the prompt, and then click OK.
Enabling Embedded Security after permanent disable
To enable Embedded Security after permanently disabling it:
1. Select Start > All Programs > HP ProtectTools Security Manager.
2. In the left pane, click Embedded Security, and then click Advanced.
3. In the right pane, under Embedded Security, click Enable.
4. Type your owner password at the prompt, and then click OK.
Migrating keys with the Migration Wizard
Migration is an advanced administrator task that allows the management, restoration, and transfer of
keys and certificates.
For details on migration, refer to the Embedded Security online Help.
Advanced tasks 29
To Next Page
Loading...
