2-4
Compaq Professional Workstation AP550 Maintenance and Service Guide
Tools and Software Requirements
To service the workstation, you might need the following:
■
Torx T-10 screwdriver
■
Torx T-15 screwdriver
■
Flat-blade screwdriver
■
Diagnostics diskette
IMPORTANT:
Before servicing the workstation, be sure that the drivers from the latest Compaq
workstation SSD for Windows NT are installed. See Chapter 4 for installation procedures.
Warranty Information
The workstation comes
standard
with the following warranties:
■
Standard Warranty
–Refer to the warranty card included with the unit.
■
Pre-Failure Warranty
–A special warranty that extends the Compaq three-year limited
warranty by applying it to critical system components before they fail. This warranty
ensures that when you receive notification of a prefailure condition through Compaq
Insight Manager or the Windows NT Event Log, the component is replaced under
warranty.
NOTE:
For more information about Compaq Insight Manager, see Chapter 4.
The Pre-Failure Warranty covers the following workstation components:
Y
SCSI hard drives
Y
Error Correcting Code (ECC) memory
Y
Pentium III processor
In addition to the above warranties, an optional Extended Warranty is available through
CarePaq. A post warranty contract is also available on this product. If purchased, this warranty
extends the Standard Warranty’s one-year coverage for labor and on-site service by two
additional years.
IMPORTANT:
Observe all warnings and cautions provided herein. Failure to do so may void warranty for
damaged components.
To Next Page
Loading...
