3-28
Compaq Professional Workstation AP550 Maintenance and Service Guide
Card Guide
To remove the card guide:
1. Perform the steps in the “Service Preparations” section as previously shown.
CAUTION:
Before removing the workstation access panel, ensure that the workstation is
turned off, all cables are disconnected from the back of the workstation, and the power cord is
disconnected from the grounded AC outlet.
2. Remove the workstation access panel.
3. Remove any full-length expansion boards.
4. Push down on the two tabs on the top of the card guide 1.
5. While holding the tabs down, remove the card guide from the chassis 2.
2
1
Figure 3-27. Removing the card guide
To replace the card guide, reverse the above procedure.
To Next Page
Loading...
