Removal and Replacement Procedures
3-15
7. To remove the bracket brace from the top of the drive adapter, squeeze in on both sides of
the brace 1, then rotate the brace up and out 2.
8. Remove the drive bezel 3.
9. Remove the screws that secure the hard drive to the drive adapter 4.
10. Remove the hard drive from the drive adapter 5.
1
1
2
4
3
5
4
Figure 3-15. Removing a 3.5-inch drive from the 5.25-inch drive adapter
To replace the drive, reverse the above procedure.
IMPORTANT:
The primary 3.5-inch diskette drive should only be installed into bay 3.
NOTE:
If you are installing a second 3.5-inch diskette drive into bay 1 or 2 for the first time, you must
use a special adapter bracket. (See Chapter 1 for the spare part number.)
If you are installing a 3.5-inch diskette drive into bay 3, you must use a special adapter bracket. (See
Chapter 1 for the spare part number.)
To Next Page
Loading...
