3-26
Compaq Professional Workstation AP550 Maintenance and Service Guide
Refer to the following illustration to install a PCI expansion board.
1. Slide the expansion board into the expansion slot and press it firmly into place.
Figure 3-25. Installing an expansion board
IMPORTANT:
When you install an expansion board, press firmly on the board so that the whole
connector seats properly in the expansion board slot.
NOTE:
If you are installing a full-length PCI expansion board, make sure the board is engaged with the
card guide.
2. Replace the screw at the side of the expansion slot.
3. Replace the workstation access panel.
4. Connect external cables to the installed board, if needed.
5. Plug the network cable back into the system. Plug the power cord back into the grounded
AC outlet. Reconnect external devices.
To Next Page
Loading...
