3-42
Compaq Professional Workstation AP550 Maintenance and Service Guide
5. Pull out the retaining tabs on each side of the terminator board 1, and then lift the
terminator board out of the socket 2.
1
1
2
Figure 3-36. Removing the terminator board from the secondary processor slot
Figure 3-37. Installing a second processor/heatsink assembly
6. Push the processor/heatsink into the secondary processor slot until it locks firmly into
place.
IMPORTANT:
Do not mix processors. The second processor must be the same speed, cache size, and
type as the existing processor.
Reassemble the workstation, and connect the power cord to the grounded AC outlet and to the
workstation.
IMPORTANT:
Be sure to tighten both thumbscrews when replacing the workstation access panel.
To Next Page
Loading...
