Removal and Replacement Procedures
3-61
9. Gently pull the subpanel, with the bezel blank secured, away from the front bezel and
rotate the bezel blank clockwise 90 degrees.
CAUTION:
Hold the subpanel straight when you pull it away from the front bezel. Pulling the
subpanel away at an angle could damage the pin alignment.
2
1
Figure 3-54. Rotating the bezel blanks when converting a desktop
1
to a minitower
2
10. Replace the subpanel and front bezel, ensuring the subpanel and front bezel align properly
with the alignment tabs.
CAUTION:
When replacing the subpanel, be sure the aligning pins and any remaining bezel
blanks are in the proper orientation to prevent damage to the alignment pins. See Figure 3-7
for the subpanel keyed-alignment positions.
11. Reassemble the workstation.
NOTE:
When switching from desktop to minitower orientation, the bezel blank should be switched out
with the replacement provided to ensure that the Compaq logo is properly oriented.
To Next Page
Loading...
