select the best display configuration, and install the appropriate display
drivers. This automated setup is referred to as Plug and Play; there are
no switches to set or manual procedures to follow; just plug it in.
NOTE: A monitor with AssetControl is required for the Plug and Play setup
to work. If you do not have a Plug and Play monitor, you can set up
your display manually.
Supported Resolutions
Resolutions supported by the two graphics controllers installed on the
Compaq ProLinea Family of Personal Computers are presented in the
following Tables:
Table 7-2a. Supported Graphics Resolution for the Compaq QVision 2000+
Graphics Controller
===========================================================================
Resolution Colors (2 MB VRAM) Colors (4 MB VRAM)
===========================================================================
1280 x 1024 256 up to 16,777,216
1024 x 768 up to 65,536 up to 16,777,216
800 x 600 up to 16,777,216 up to 16,777,216
640 x 480 up to 16,777,216 up to 16,777,216
===========================================================================
Table 7-2b. PCI Local Bus Integrated Graphics Controller
===========================================================================
Resolution Colors (1 MB DRAM) Colors (2 MB DRAM)
===========================================================================
1280 x 1024 16 ** up to 256 **
1024 x 768 up to 256 up to 65,536
800 x 600 up to 65,536 up to 16,777,216
640 x 480 up to 16,777,216 up to 16,777,216
---------------------------------------------------------------------------
** Interlaced mode
===========================================================================
For more information on upgrading the graphics memory, refer to Chapter 5,
"Removal and Replacement Procedures."
Changing Monitor Type Manually
Although the setup utility automatically detects Plug and Play monitor
types, if you are not using a Plug and Play monitor, you can manually
select or change the monitor type. The procedure varies slightly for each
graphics controller.
NOTE: If you are not sure which graphics controller is installed on the
computer, run Compaq Diagnostics to identify the installed controller.