EasyManua.ls Logo

Compaq Prolinea Family - Page 42

Compaq Prolinea Family
197 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
XXXX - 14 Drive hardware error
---------------------------------------------------------------------------
XXXX - 15 Illegal drive command Replace the indicated device.
---------------------------------------------------------------------------
XXXX - 16 Media was changed Replace the indicated device.
---------------------------------------------------------------------------
XXXX - 17 Tape write protected 1. Disable write protect on tape
cartridge.
2. Replace tape drive.
---------------------------------------------------------------------------
XXXX - 18 No data detected Replace the indicated device.
---------------------------------------------------------------------------
XXXX - 21 Drive command aborted Replace the indicated device.
---------------------------------------------------------------------------
65XX - 24 Media hard error 1. Back up data and perform Surface
Analysis to reallocate defect.
2. Replace drive.
---------------------------------------------------------------------------
66XX - 24 Media hard error 1. Replace current DATA CD with
different DATA CD
2. Replace drive.
---------------------------------------------------------------------------
67XX - 24 Media hard error 1. Ensure correct media type for this
tape drive.
2. Replace current tape with new tape.
3. Replace tape drive.
---------------------------------------------------------------------------
XXXX - 25 Unknown
---------------------------------------------------------------------------
Error
Code Description Recommended Action
---------------------------------------------------------------------------
XXXX - 30 Controller timed out Replace the indicated device.
XXXX - 31 Unrecoverable error
XXXX - 32 Controller/drive
disconnected
XXXX - 33 Illegal controller
command
XXXX - 34 Invalid SCSI bus phase
XXXX - 35 Invalid SCSI bus phase
XXXX - 36 Invalid SCSI bus phase
XXXX - 39 Error status from
drive
XXXX - 40 Target timed out
XXXX - 41 SCSI bus stayed busy
XXXX - 42 ACK/REQ lines bad
XXXX - 43 ACK did not deassert

Related product manuals