Need help?Do you have a question about the Compur Monitors Statox 506 and is the answer not in the manual?
Describes how to install the Statox 506 sensor head, including mounting and environmental considerations.
Details electrical connection requirements, including intrinsically safe repeater specifications and cable capacity calculations.
Wiring diagrams for connecting the Statox 506 to a control module in 2-wire mode for hazardous and non-hazardous areas.
Wiring diagrams for connecting the Statox 506 to a control module in 3-wire mode for hazardous and non-hazardous areas.
Explains how to access the main menu using a password and navigate through service modes.
Details the procedure for adjusting the internal clock for accurate logging and protocols.
Describes how to set the analog output current (2 or 4 mA) during service mode operation.
Explains the procedure and requirements for calibrating the sensor using calibration adapter and span gas.
Outlines the procedure for performing a prooftest to verify sensor and head functionality.
Describes accessing alarm history, total exposure (dosis), and sensor details like serial number.
Explains how to use the test menu for checking sensor, display, temperature, and watchdog.
Lists and explains various status messages displayed by the sensor head during operation.
Lists and explains error messages, their causes, and recommended corrective actions.
Describes the safety function of the Statox 506 in detecting gases and its analog output.
Details the diagnostic delay and the measuring cycle for system monitoring and failure detection.
Specifies mandatory parameter settings for achieving required failure rates and Safe Failure Fraction.
Lists mandatory maintenance procedures necessary for ensuring functional safety.
Provides guidelines for hardware repair work and the mandatory use of original spare parts.
Presents hardware assessment data on failure rates and the Safe Failure Fraction (SFF) of the device.
Details the calculation of Average Probability of Dangerous Failure on Demand (PFDavg).
Explains the device's compliance with SIL 2 rating requirements as per IEC 61508-2:2010.
States the transmitter lifetime without sensor and the validity period of failure rates.
Provides general technical specifications including operating temperature, power supply, and dimensions.
Lists typical data for the electrochemical sensors, including temperature and humidity ranges, and response times.
General| Measuring Principle | Electrochemical |
|---|---|
| Operating Temperature | -20°C to +50°C |
| Gases | O2 |
| Response Time | < 15 sec |
| Operating Humidity | 0-95% RH (non-condensing) |
| Resolution | 0.1 |
To Next Page