6 Menu
6.1 Main Menu
Push the ENTER – button in order to enter the main menu. Use the left / right – buttons to enter the
password “94”. This password cannot be changed.
You can navigate in the main menu in either direction. Enter a sub menu by pushing the ENTER – button.
RESET brings you step by step back into the measuring mode.
After you have entered the password, the sensor head is now in the service mode. The output is set to 2
or 4 mA. The measured value will not be transmitted.
If you do not operate a button for more than 5 minutes, the sensor head will return automatically into the
measuring mode. Exceptions to this are listed in the relevant sub menus.
To Next Page
Loading...