Computherm E400RF - Modifying Temperature until the Next Switch in the Program

- 34 -
times (temperature, hour value of the time, minute value of the time).
- Values are always set by buttons.
After the program of weekdays has been set, you can set the program
of the days of the weekend. The day and switch being set are shown
by the icon ashing on the display.
d) Programs that were set earlier can be checked at any time by repeating
the steps of programming mode.
Attention! In the interest of logical programming ensure that in programming
the times of successive switches succeed each other during the course of the
day, i.e. you should specify switches in chronological order.
12.2.3. Modifying temperature until the next switch in the program
If the thermostat is in programmed mode, but you want to temporarily change
the set temperature until the next program switch, you can do so as follows:
• Using the phone application: using the icons or mo ving the slide (groo-
ve) on the circular scale, the icon will appear in the application instead of
the icon.
• On the thermostat: using the buttons. The thermostat’s display will show
and at the same time.
The set temperature this way will remain in e󰀨ect until the next program switch.