M a i n t e n a nc e l 5- 7
5
M a i n t e n a n c e
C l e a n i n g th e R e g e n er a ti o n Fil t er
Clogged filters reduce air flow and dryer efficiency. Cleaning frequency depends on how
much material you process and how dusty or full of fines it is.
1 Push in on the sides to release the
tabs on the front cover. Remove the
cover.
2 Remove outer filter and clean it with
soapy water. Let the outer filter air dry.
3 Loosen the hose clamp holding the
regeneration filter onto the regenera-
tion inlet and remove the filter.
4 Clean dust, fines, and dirt from
the filter, or replace it with a new
filter. Clean the filter by laying it
on its side and gently tapping it on
the floor. Replace damaged, worn,
or clogged filters.
5 Reverse the procedure to reinstall
the regeneration filter.
CAUTION: Wear eye protection. If you use compressed air to clean the
equipment, you must wear eye protection and observe all OSHA and
other safety regulations pertaining to the use of compressed air.