4 - 2 l O pe r a t io n
D r y er Sy s t e m Co n tr o l Pan e l
On power-up, the Carousel Plus Dryer control displays the initial system Home screen.
At start-up, the system security level is "Default". Once the operator clicks the Login but-
ton and enters the user name and password, access is permitted to various areas of the con-
trol. The user, depending on security access level, can access the various system and setup
screens for the entire Carousel Plus Dryer system.
Your DC-T Carousel Plus Dryer Control has been configured at the factory based on the
configuration you chose when placing the order. The DC-T can be configured for use with
a ResinWorks dryer with multiple hoppers, a central dryer with separate heat source to
multiple hoppers, or as a stand alone dryer with a single hopper. Once this factory configu-
ration is set (based upon your order) a customer can not change this configuration. The
screens, the screen flow, and operation will differ greatly depending on which configuration
you are using. The Operation section of this user guide covers each of the three configura-
tions individually.
NOTE: The bottom of the Home
screen displays valuable infor-
mation, including the current
date and time, the HMI software
version, the dryer board ver-
sion, and Conair’s copyright.
The software version and board
version will be helpful for serv-
ice and troubleshooting purpos-
es.
✐
Dryer board version
HMI software version
Stand alone dryer
Central or ResinWorks dryer
To Next Page
Loading...
Need help?
General
