Conair Carousel Plus W Series - Page 56

4 - 2 2 l Op e ra ti o n
C o n t r o l Fun c ti o n D es c ri p ti o ns - R W
C o n f i g u r a ti o n
( c o n ti n ue d )
ResinWorks System Setup screen
To access the ResinWorks Setup screen:
1 Press the Settings button from the Home screen.
2 Press the ResinWorks Setup button.
The ResinWorks System Setup screen provides the user with the ability to change the sys-
tem settings of this ResinWorks system.
This screen allows you to change:
• Hopper and hopper heater count
• Units selection (Fahrenheit and Celsius)
• Drying Monitor (DM3-e) enabling
• Dryer model
• Clock display (12 hour and 24 hour)
• Voltage selection
NOTE: Your DC-T control should
have been configured at the factory
for your ResinWorks system. These
settings should not need changed
unless your system changed, or the
control was replaced. Proper login
is required to change these set-
tings.
✐
NOTE: See the Appendix of this
User Guide for more information
about using the DM3-e Drying
Monitor.
✐
(continued)