Conair Thermolator TW-1 User Manual

Thermolator TW Series UGH025-0504
3-16 INSTALLATION
Press the RUN button to save the control
point.
u
The control will display “Pr OFF” to prompt you to
remove power to the unit.
IMPORTANT: If RUN is not pressed, the new
control point source will not be saved.
Turn off power to the unit.
Disconnect and lock out the
main power supply.
Open the electrical
enclosure.
Set dip switch 5 to OFF.
Close the electrical enclosure and restore
power to the unit. The TW-2 will now control the process
temperature based on actual temperatures recorded at the
new control point source.
8
9
10
11
876
54
3
21
12
TW-2 CONTROL
SELECTING THE
TEMPERATURE
CONTROL POINT
CONTINUED

Conair Thermolator TW-1 Specifications

General

Brand	Conair
Model	Thermolator TW-1
Category	Control Unit
Language	English