Need help?Do you have a question about the ConMed System 2450 and is the answer not in the manual?
Details the functional parameters for each electrosurgical mode.
Explains the main components and how the system functions.
Describes configuration dipswitch settings for factory defaults.
Provides general guidance for ensuring safe and effective operation.
Specifies qualified personnel for performing service and maintenance.
Instructions for cleaning the exterior and interior of the unit.
Guidelines for visual inspection of the unit every six months.
Procedures for annual testing to ensure correct performance.
Steps to prepare the system for calibration mode.
Procedure for selecting major and minor modes for calibration.
Steps for calibrating monopolar modes (Cut, Blend, Coag).
Steps for calibrating bipolar modes.
Procedure to calibrate the Automatic Return Monitor (A.R.M.).
Final steps to complete the system calibration process.
Procedure to retrieve stored error and accessory codes.
Steps to clear the entire fault code memory.
Specific troubleshooting advice for the High Voltage Power Supply.
Instructions for removing and replacing the unit's top cover.
Instructions for removing and replacing the unit's bezel.
Instructions for removing and replacing the control/display board.
Instructions for removing and replacing the power board.
Instructions for replacing power transistors on the power board.
General| Brand | ConMed |
|---|---|
| Model | System 2450 |
| Category | Portable Generator |
| Language | English |
To Next Page
