ConMed System 2450 - Table of Contents

Table of Contents
& List of Illustrations
Section Title Page
1.0 General Information .................. Refer to Operator’s Manual (60-2451)
2.0 Specifications ............................. Refer to Operator’s Manual (60-2451)
3.0 Theory of Operation ......................................................................... 3-1
3.1 Mode Descriptions ...................................................................................... 3-1
3.1.1 Cut Major Modes ..............................................................................................................3-1
3.1.2 Coag Major Modes ...........................................................................................................3-1
3.1.3 Bipolar Major Modes ........................................................................................................3-1
3.2 System Overview ......................................................................................... 3-1
3.2.1 RF Power Supply (RFPS) .................................................................................................3-4
3.2.2 RF Amplifier and Transformer ..........................................................................................3-4
3.2.3 Electrosurgical Outputs ...................................................................................................3-4
3.2.4 Activation Command Sensing .........................................................................................3-5
3.2.5 Automatic Return Monitor (A.R.M.) ................................................................................3-5
3.2.6 System Controllers and Monitor .......................................................................................3-5
3.2.7 Low Voltage Power Monitoring ........................................................................................3-5
3.2.8 Operator Control Panel ..................................................................................................... 3-5
3.2.9 Activation Tones................................................................................................................3-6
3.2.10 Activation Relay Connector...............................................................................................3-6
3.3 Optional System Configurations ................................................................. 3-6
4.0 Maintenance ...................................................................................... 4-1
4.1 General Maintenance Information ............................................................... 4-1
4.2 Maintenance Personnel ................................................................................ 4-1
4.3 Cleaning ...................................................................................................... 4-1
4.4 Periodic Inspection ......................................................................................4-1
4.5 Periodic Performance Testing ...................................................................... 4-1
4.5.1 Chassis Ground Integrity ..................................................................................................4-1
4.5.2 Displays, Alarms and Commands ...................................................................................... 4-1
4.5.3 Output Power ...................................................................................................................4-2
4.5.4 RF Leakage Measurement ................................................................................................. 4-3
4.5.5 Line Frequency Leakage ....................................................................................................4-4
4.5.6 Automatic Return Monitor (A.R.M.) Check ..................................................................... 4-5
4.5.7 Output Coupling Capacitor Check .................................................................................... 4-5
4.6 System Calibration ...................................................................................... 4-6
4.6.1 Calibration Preliminaries ..................................................................................................4-6
4.6.2 Selecting the Mode to Calibrate ........................................................................................4-6
4.6.3 Calibrating a Monopolar Mode .........................................................................................4-8
4.6.4 Calibrating Bipolar Modes ................................................................................................4-8
4.6.5 Calibrating A.R.M. ...........................................................................................................4-8
4.6.6 Completing Calibration .....................................................................................................4-9
4.7 Last Fault Code Retrieval & Clear .............................................................. 4-9
4.7.1 Last Fault Code Retrieval .................................................................................................. 4-9
4.7.2 Clearing Last Fault Codes .................................................................................................4-9
4.8 Displaying Optional System Configuration ............................................... 4-9