Loading Originals 20
Soft Handling
The Soft-handling option can be selected in your scan application. Soft-
handling means that feeding and scanning are slowed down. You can use
the option with both Manual and Automatic loading.
NOTE: The availability of the soft handling load option depends on your
scan/copy software and its level of compatibility with the scanner model.
Use Soft-handling with
1. Old, curled or creased originals that trigger a paper jam. See Trouble
Shooting – Paper Jam error for correcting a paper jam error.
2. Fragile originals you want passed delicately through the drive system.
Setting the input size
The Input size defines the scan area. You enter the input size in your
application’s input size dialogs.
NOTE: The availability of the Input size options described below will
depend on your scan/copy software and its level of compatibility with the
scanner model.
3 ways to set find and set the input size:
3. Use automatic size detection - The scanner will detect the edges of
the document and calculate the input size for you.
4. Set a standard size - common standard sizes are marked on the
scanner bed. Use these markings to determine which standard size
matches the original and then select that size in the application’s input
size dialog.
5. Set the size manually for irregular sizes. Measure your document with
the inch/cm ruler on the scanner bed. Enter your width measurement in
the width setting field in your application’s input size setup dialog. You
can also measure and set a length value or choose automatic length
detection.
To Next Page
Loading...
