Installation 8
Clean the scanner feeding bed
This is the flat surface in front of the insertion slot. Wipe thoroughly so dirt
and dust are not dragged into the scan area with the original.
Open the scanner lid –
Press the lid release buttons
The internal scan area should be wiped clean for any dust accumulated
during packaging and shipping. The scan area is under the scanner lid so
you have to open it. The scanner lid release buttons are at the back of the
lid.
1. Stand at the front of the scanner.
2. Push down on the lid and simultaneously slide both release buttons
towards the scanner’s center with your fingers until you feel them
unlock.
3. Use your other fingers to grip the edge of the lid.
6
5
To Next Page
Loading...
