Conti CC100 - PROGRAMMING

Edition 04/2010 - CC100
NOTES TECHNIQUES - TECHNICAL DOCUMENTS - page 22
SACOME, Document CONFIDENTIEL, Ne peut être reproduit ni communiqué sans notre accord préalable.
SACOME, CONFIDENTIAL Document, it is forbidden to duplicate or communicate this document without previous authorization.
19. PROGRAMMING
19.1. PROGRAMMING PROCEDURES
Programming is done on the group 1 (left group), the 5 keys are defined as follows:
P1 Gr1 P2 Gr1 P3 Gr1 P4 Gr1 P5 Gr1
1shot 2shots 1regular 2regular continuous
espresso espresso coffee coffee flow
19.1.1. Programming doses:
To have access to program volumetric doses (flowmeters), you have to use the last button on the
right "P5 Gr1 (continuous flow key) on the remote control group 1.
The programming operations must begin within 10 seconds after the entry into programming
mode otherwise it will automatically exit programming mode.
a) Press the continuous flow key "P5 Gr1" and hold for 5 seconds until the button "P5 Gr1"
flashes.
b) Release the button "P5 Gr1". Press the key to program, the LED of this button is lit during the
programming procedure and the button "P5 Gr1" continues to flash.
c) When the desired dose is reached, make a second push on the same key, the light goes out but
the key "P5 Gr1" continues to flash
To program another button, repeat the procedure within 10 seconds
The programming of the 1st group is copied to the other groups, but they can be programmed
independently.
19.1.2. Programming of pre-brewing (1sec On / 1sec Off) :
The pre-brewing is only available on Espresso (1 or 2 shots).
The pre-brewing is adjusted by default on these 2 buttons, if the user wants to delete it, one must
proceed as follows:
_ Settings without pre-brewing:
a) Turn off the machine.
b) Keep pressing the key “P2 Gr1” then turn the machine on.
c) When the LED of the key “P5 Gr1” key lights, turn off the machine again.
d) Wait a few seconds then turn on the machine.
_ Setting the machine with pre-infusion:
a) Turn off the machine.
b) Keep pressing the key “1 shot espresso” then turn the machine on.
c) When the LED of the “continuous flow” key lights, turn off the machine again.
d) Wait a few seconds then turn on the machine.