Control Microsystems SCADAPack 32 - Field Wiring Connectors; Figure 1: 5232 Controller Board Layout

• Push the connector onto the pins. Apply even pressure to both ends of the connector.
3.2.1 Field Wiring Connectors
The controller board has six termination connectors for field wiring. Refer to Figure 1: 5232
Controller Board Layout for connector locations.
Primary power input connections; output power connection and ground connections are wired to a
six-pole connector labeled P3. Refer to section 4-Power Supply subsection for instructions on how to
wire the controller board to a power supply.
The three digital/counter inputs (DIN/Counters), interrupt input/counter (INT/Cntr) and status output
(STATUS) are wired to an eight-pole connector labeled P4. Refer to section 7-Digital Inputs and
section 8-Digital Outputs for more information.
Each of the three serial communication ports is wired to black 8 pin modular RJ-45 connectors.
COM1 connector is labeled P6, COM2 connector is labeled P7, and COM4 connector is labeled P8.
Refer to the section 9.1-RS-232 Serial Communication Ports for more information
The Ethernet LAN Port is wired to a gray 8 pin modular RJ-45connector labeled P5. Refer to the
section 10- Ethernet Communication for more information on Ethernet connections.
0 1 2
COM
+ –
ST A TU S
+ –
INT
AC/ DC
PWR
IN
+ –
DC PWR
5V LEDS ST AT RUN
FORCE
INT CTR1 CTR2CT
R
LAN
LIN
TX
RX
CT
S
DCD
T
X
RX
CT
S
DCD
TX
RX
CT
S
DCD
Po w er Su p p l y an d CPU
Interupt and Counters
COM1
COM4
LAN COM2
SW1
P11
F2
F1
J5
TX
RX
RS4 8 5
RS232
J7
J8
J9 J1
COM Port
J4
P1
P2
BT1
P6
COM1
RS-232/ 485
P7
COM2
RS-2 3 2
P8
COM4
RS-2 3 2
P5
LAN
LED POWER
P4
P3
P1 1
P9
J2
J3
Figure 1: 5232 Controller Board Layout
SCADAPack 32 Controller Hardware Manual
May 24, 2006
9