Control Microsystems SCADAPack 32 - RS-485 Cable

9.7 RS-485 Cable
This cable is used to connect from an RJ-45 based RS-485 port on the SCADAPack 32 controller to
other RS-485 devices. The cable has a RJ-45 connector on one end and stripped wires at the other
end. A 10-foot long cable is available from Control Microsystems as part number 297234.
RJ45 Function Wire Color
Connect to Chassis Shield
3 –Tx Orange
6 +Tx Blue
5 +Rx Grey
2 –Rx Brown
4 GND Black
7 Do not connect. Yellow
8 Do not connect. Green
1 +5V Red
SCADAPack 32 Controller Hardware Manual
May 24, 2006
35