14 Specifications
Disclaimer: Control Microsystems reserves the right to change product specifications without
notice. For more information visit
www.controlmicrosystems.com .
14.1 General
I/O Terminations
6,8,9 and 10 pole, removable terminal blocks.
12 to 22 AWG
15A contacts
Dimensions
SCADAPack
8.40 inch (213mm) wide
6.13 inch (155mm) high
2.80 inch (72mm) deep
Packaging
corrosion resistant zinc plated steel with black enamel paint
Environment
5% RH to 95% RH, non-condensing
–40
o
C to 70
o
C
–40
o
F to 158
o
F
Processor
Hitachi SH-3 32-bit CMOS microcontroller
120 MHz. clock
Memory
4Mbytes Flash
8Mbytes SDRAM
1024kBytes CMOS RAM
Non-volatile
RAM
CMOS RAM with lithium battery retains contents for 2 years
with no power
Clock calendar
±1 minute/month at 25°C
+1/–3 minutes/month 0 to 50°C
Internal
temperature
Measurement range -40°C to 75°C. Accuracy ±5°C.
Measurement range -40°F to 167°F. Accuracy ±9°F.
Lithium battery
monitor
Accuracy ±0.2V.
14.2 Communications
Communication
Ports, 5232
controller board
2 RS-232 serial
ports (COM2,
COM4)
Data Terminal
Equipment (DTE)
8 pin modular jack
1 RS-485 serial port (COM1)
2 wire half duplex
4 wire full or half duplex
optional termination resistors
RS-232:
Data Terminal Equipment (DTE)
8 pin modular jack
RS-485:
2 wire half duplex
4 wire full or half duplex
optional termination resistors
Baud Rates (COM1,
COM2, COM 4)
300, 600, 1200, 2400, 4800, 9600, 19200, 38400,
57600 and 115200.
Default: 9600
SCADAPack 32 Controller Hardware Manual
May 24, 2006
51
To Next Page
Loading...
