Control Microsystems SCADAPack 32 - Page 4

9.1.1 COM1 ..................................................................................................... 24
9.1.2 COM2 ..................................................................................................... 25
9.1.3 COM4 ..................................................................................................... 26
9.2 RJ-45 Modular Connector for RS-232.......................................................... 26
9.3 DE-9P Connector for RS-232....................................................................... 28
9.4 RS-232 Cables............................................................................................. 29
9.4.1 RJ-45 to DE-9S DTE .............................................................................. 29
9.4.2 RJ-45 to DE-9P DCE .............................................................................. 29
9.5 RS-232 Wiring Examples ............................................................................. 29
9.5.1 DTE to DTE without Handshaking .......................................................... 29
9.5.2 DTE to DTE with Handshaking ............................................................... 30
9.5.3 DTE to DCE with Handshaking............................................................... 30
9.6 RS-485 Serial Communication Port ............................................................. 31
9.6.1 RJ-45 Modular Connector for RS-485 .................................................... 31
9.6.2 RS-485 Bias Resistors............................................................................ 32
9.6.3 RS-485 Termination Resistors................................................................ 32
9.6.4 RS-485 Wiring Examples........................................................................ 33
9.7 RS-485 Cable............................................................................................... 35
10 ETHERNET COMMUNICATION.................................................................. 36
10.1 LAN Port Settings......................................................................................... 36
10.1.1 TCP/IP Settings ...................................................................................... 36
10.1.2 Modbus/TCP Settings............................................................................. 36
10.1.3 RJ-45 Modular Connector for Ethernet................................................... 37
11 OPERATION................................................................................................ 39
11.1 Operating Modes.......................................................................................... 39
11.1.1 Run......................................................................................................... 39
11.1.2 Service.................................................................................................... 39
11.1.3 Cold Boot................................................................................................ 39
11.2 LED Indicators.............................................................................................. 40
11.3 Led Power Control ....................................................................................... 41
11.4 Status LED and Output ................................................................................ 41
11.4.1 I/O Module Error Indication..................................................................... 42
11.4.2 Register Assignment Checksum Error.................................................... 42
11.4.3 Too Many I/O Operations Requested Error ............................................ 42
SCADAPack 32 Controller Hardware Manual
May 24, 2006
3